Duet 2 Wifi Setup

Use this for your Workhorse Printer Setup but with Duet 3 Setup

1. Connect the Duet to your PC with the USB cable provided. Do not connect other power supplies at this stage.

2. Windows users, download the USB drivers for Duet here and extract the files to a suitable location.

3. Install Drivers.

4. Download YAT Terminal Interface.

5. Setup YAT to use <LF> as the end of line character. Go to "Terminal" Menu -> "Settings" -> "Text Settings" -> "EOL sequence:" set to <LF>

6. Windows Users: Open YAT, and configure the correct COM port.

1. send command M115

2. The WiFi module has a blue LED on it, just next to the Micro SD card holder. This should flash once when power is connected to the board, but will only be lit permanently when connected to a WiFi network. Duets with an external antenna use a different WiFi module with no LED; if you have one of these, don't forget to plug in the external antenna!

3. Send M552 to check the status. It should say "WiFi module is disabled". Now put it into idle mode by sending command M552 S0. Send M552 again to check it's idle, then proceed to the next step.

Related Content 

Workhorse Printer 
Duet3D